Cut seven strips of wax paper, 36 inches long and 6 inches wide. Cut seven strips of aluminum foil, 35 inches long and 5 ¾ inches wide. Cut two 4-inch lengths of copper wire.
Lay one strip of wax paper on a flat surface and center one strip of aluminum foil over it. Using transparent tape, tape one copper wire lead to the upper right corner of the first layer of aluminum foil. The copper wire should overlap the top edge of the foil by 1 inch with the remaining 3 inches above the foil.
Lay a strip of wax paper over the first layer of foil. Lay the remaining strips of foil and paper in alternating layers. Using transparent tape, tape one wire to the lower left corner of the last strip of aluminum foil. The copper wire should overlap the bottom edge of the foil by 1 inch with the remaining 3 inches below the foil.
Starting at either end, roll the layers as tightly as possible from one end to the other. Wrap transparent tape around the rolled paper/foil cylinder to prevent unwinding of the roll.
Light a candle and drip melted wax over both ends of the paper/foil roll to seal the ends. The paper/foil capacitor is ready for charging via its copper leads.