Drill two holes in the bottom of the wooden box. Set them ¼ inch apart. Use a drill bit that is the same size as, or slightly wider than, the coat hanger wire. Cut a small notch (approximately ½ inch wide and deep) in the top of one of the walls of the box, using the hacksaw.
Straighten out the coat hangers. Use pliers to bend out all the kinks by grabbing the wire with one pair just below the kink and the other just above it. Depending on the style of transformer output terminals you have it may be helpful to bend one end of each wire into a hook.
Attach the coat hanger wires to the output terminals of the neon sign transformer. Push the wires through the holes in the bottom of the box so that the box settles onto the floor covering the transformer with the wires poking out through the holes. Bend the wires so that they are approximately 3 inches apart at their tops.
Make sure that the power cord for the neon sign transformer is poking out of the box through the notch. Lay the assembly on its side. Screw the lid of the box onto the box itself. Plug the power cord in to operate.